How To Reset Oil Life On 2012 Chevy Malibu


Where is my TPMS reset button?

In most vehicles the TPMS reset button is found beneath the steering wheel. After changing the tires on your vehicle, the TPMS needs to be electronically reset in order to clear the error code. To do this, hold in the TPMS reset button until the tire pressure light blinks three times, then release the button.

How To Reset Oil Life On 2012 Chevy Malibu tire pressure

How do you reset the tire pressure light on a 2012 Chevy Malibu?

To reset the tire pressure monitor or tpms system in your 2012 Chevy malibu turn the ignition key to the "on" position and depress the tpms button, usually located under the dash, until the tpms light blinks several times. Start your vehicle and let it run for at least 20 minutes and your tpms system should be reset.

How do you reset the tire pressure monitoring system on a 2013 Chevy Malibu?

To reset the tire pressure monitor or tpms system in your 2013 Chevy malibu vehicle, turn the ignition key to the "on" position and depress the tpms button, usually located under the dash, until the tpms light blinks several times.

How do you reset the trip meter on a Chevy Malibu?

Go ahead and press the reset button shown on Your odometer area for a few seconds. Once You see it go down to 0, You’re done. If it did not work, repeat the process again until You get that 0. You can reset the odometer any time that You need to do it.

Does 2012 Chevy Malibu use synthetic oil?

The manual on the 2012 says you must use a Dexos 1 approved oil. The manual recommends ACDelco Synthetic Blend.

How do you reset the meter on a 2010 Chevy Malibu?

Press and hold the INFO button on the DIC for 1 second in order to reset the trip odometer display.

How To Reset Oil Life On 2012 Chevy Malibu Chevy Malibu

How do you reset the check engine light on a 2015 Chevy Malibu?

The simplest way to reset the engine light is to remove the negative battery terminal cable for two minutes, and then replace it. If this doesn’t reset the light, you will have to use a code reader to erase the error codes. This should reset the light.

How much oil does a 2012 Chevy Malibu take?

Chevrolet’s 2012 Malibu LS came equipped with a 2.4-liter, inline four-cylinder engine bolted to a six-speed automatic transmission. When you change the oil and filter, the 2.4-liter engine takes five quarts of oil to refill the system.

Share the right answer